Hello
Since I upgrade to version 9, when IB is reloaded using TWSStart @ 10 pm, MC stop and wait for me to click on the TWS version Web or Stand alone if I recall
Can I set it so it load the "Stand alone" TWS version
Martin
MC 9.0 How to set "Stand alone" for IB data server
- Henry MultiСharts
- Posts: 9165
- Joined: 25 Aug 2011
- Has thanked: 1264 times
- Been thanked: 2957 times
Re: MC 9.0 How to set "Stand alone" for IB data server
Hello Martin,
TWS version selection is triggered only when you go to IB data feed settings and press Reset. I do not think it can also be triggered by TWSStart. That is possible that in IB TWS you do not have 127.0.0.1 in trusted IPs.
TWS version selection is triggered only when you go to IB data feed settings and press Reset. I do not think it can also be triggered by TWSStart. That is possible that in IB TWS you do not have 127.0.0.1 in trusted IPs.
Re: MC 9.0 How to set "Stand alone" for IB data server
Hello HenryHello Martin,
TWS version selection is triggered only when you go to IB data feed settings and press Reset. I do not think it can also be triggered by TWSStart. That is possible that in IB TWS you do not have 127.0.0.1 in trusted IPs.
I had the same message 3 times last week after the IB daily server reset @ 10 pm my time. Did not get it today.
Nothing was change on IB TWS. Message started to appear after I Installed MC 64.
Will see how it goes this week and report if happen again
Martin