Hello,
Chart #1 data 1"
Chart #2 same data 5"
strategy :
just 1 line
print(Date,Time, XAverage( Close of data2, 12) );
question :
if data1 = 5" = data2 then print is different than if data1 = 1"
Why the Xaverage of Data2 is diferent following UT oF Data1. I always refer only to data2, which is 5" ?
Many thanks for any reply
regards
Samuel
Xaverage - data2 - not good value
-
- Posts: 103
- Joined: 05 Sep 2007
- Has thanked: 8 times
- Been thanked: 6 times
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
-
- Posts: 103
- Joined: 05 Sep 2007
- Has thanked: 8 times
- Been thanked: 6 times
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
Dear Laurent,
I asked you about the resolution because if you use tick-based resolutions the values will never coincide. When plotting non-time based resolutions within the same chart window it is impossible to sinchronize them. The bars will never be plotted under each other: where you already have bar 2 on data #1, you will still have bar 1 on data#2 etc. The attached screenshot will illustrate what I am talking about.
I asked you about the resolution because if you use tick-based resolutions the values will never coincide. When plotting non-time based resolutions within the same chart window it is impossible to sinchronize them. The bars will never be plotted under each other: where you already have bar 2 on data #1, you will still have bar 1 on data#2 etc. The attached screenshot will illustrate what I am talking about.
- Attachments
-
- TicksSeries.PNG
- (19.51 KiB) Downloaded 593 times
-
- Posts: 103
- Joined: 05 Sep 2007
- Has thanked: 8 times
- Been thanked: 6 times
ok im thinking you speak about screen resolution.Dear Laurent,
I asked you about the resolution because if you use tick-based resolutions the values will never coincide. When plotting non-time based resolutions within the same chart window it is impossible to sinchronize them. The bars will never be plotted under each other: where you already have bar 2 on data #1, you will still have bar 1 on data#2 etc. The attached screenshot will illustrate what I am talking about.
as i mention in the beginnig of my post, first chart i use 1 minute and second one 5 minutes.
The bars are ok and the "close of data2" have good value.
If you could use the same configuration on your computer, it took only 1 minute for do it, i could know if you have the same troubble
regards
Laurent
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
-
- Posts: 103
- Joined: 05 Sep 2007
- Has thanked: 8 times
- Been thanked: 6 times