hello,
How can I specify in my code to show only "x" contracts. In easylanguage you simply use "showonly" but that is not translating here.
thanks
show only
- TJ
- Posts: 7740
- Joined: 29 Aug 2006
- Location: Global Citizen
- Has thanked: 1033 times
- Been thanked: 2221 times
Re: show only
Not sure if I understand what you want.hello,
How can I specify in my code to show only "x" contracts. In easylanguage you simply use "showonly" but that is not translating here.
thanks
Can you describe your intention?
Maybe with a diagram?
-
- Posts: 222
- Joined: 16 Oct 2011
- Has thanked: 66 times
- Been thanked: 20 times
Re: show only
Hi TJ -
If I am buying 100 contracts and only want to show 10 contracts then (using easylanguage) I would code "showonly(100)".
Some would call this an iceberg order.
thanks
If I am buying 100 contracts and only want to show 10 contracts then (using easylanguage) I would code "showonly(100)".
Some would call this an iceberg order.
thanks
- Henry MultiСharts
- Posts: 9165
- Joined: 25 Aug 2011
- Has thanked: 1264 times
- Been thanked: 2957 times
Re: show only
Hello Waveslider,hello,
How can I specify in my code to show only "x" contracts. In easylanguage you simply use "showonly" but that is not translating here.
thanks
Unfortunately "showonly" code word is not supported by PowerLanguage.
Currently there is no possibility to show only "x" contracts.