That does it !

Mayny thx

ok, I'll check that Still a new issue has emerged. Since two days, when I put on the automated order execution (with IB as broker), MC loses the connection with IB (probably IB's fault) and does not reconnect automatically. Instead in TWS the pop-up "Accept incoming connection attempt appears". In b...

Hi Henry MC64 8.8 (B 8593) DP: iqFeed (realtime) furthermore, the promised follow-up: all charts/tickers which I "corrected" through having intraday data on for a while, it worked today fine without any tuning necessary. But I'll come back if the issue arises again... So to my other issue mentioned ...

yes, sure. e.g. the ticker IVE showed me only the bar from yesterday (25th) as last bar. but when i select SPY it shows correctly the 26th as last bar. I have played around a bit, and when I select intraday data for IVE, it shows correctly todays data. and when i stay for while in this chart and the...

hello after having many problems with updating in last spring, I finally downgraded. That being nearly a year ago, I thought I could give it another try. Unfortunately, to open and save workspaces takes really long in comparison to the old version. Furthermore, and this is not good, for some symbols...

That helps.

Many thx

Hello When I draw some trendlines into a chart and then zoom in, the lines are shifting somehow. I am not sure if that's supposed to be. Is there a workaround ? Example pic attached: I have drawn two trendlines into the AAPL-chart to mark the developing wedge. But when I zoom in, the lines are going...

In addition to my post directly above, I made the following observation: As I said, I installed MC now on a new Win7-installation yesterday. Then at first I had the same problem with bars not updating again. When I tried it later, it seemed to work. Today, as I figured now, the same. Usually I start...

Have you installed the hotfix as I suggested?

Certainly, and the problem persists.

I, even installed MC on a new Win 7-installation and I have the problem.

Pls help me, at the moment MC is of no use for me

As of today, intraday bar updating with iqfeed stops again when then first bar (after connecting) is finished (the initial problem is back)

Unfortunately, as I said before, after updating I face problem after problem.

Hello Henry

Compiling works again ! Thx for that.

And I have sent you my PC name via PM.

Hello Henry Thx for the timely feedback. I followed the step-by-step gui. Now I would have to restart my PC which I cannot do at the moment because the market is still open. But I will keep you posted regarding the outcome... Regarding the other issue. When I close MC, this window pops up that some ...

Hello I have to say I am really a bit angry. In March I upgraded to MC 8.5 and had a lot of problems, see my old remark (in this thread https://www.multicharts.com/discussion/viewtopic.php?f=1&t=13221) . Then after the problems could not be fixed. I installed the old version which was a hell of work...

Hello I made similar and worse experiences. I was really when lucky when I was at my desk when MC enters a position during automated trading. This position was about 50 times (!) as large as it was supposed to be. I closed it immediately and faced only a double digit loss. When I looked into this, I...