can EL statement be written to create OHLC for a speified Points
or Range size bars,so that an indicator or signal can use those values for OHLC?. Point or Range bar size will not be same as chart data.
EL statement for Point(Range) Bar
- TJ
- Posts: 7743
- Joined: 29 Aug 2006
- Location: Global Citizen
- Has thanked: 1033 times
- Been thanked: 2223 times
- TJ
- Posts: 7743
- Joined: 29 Aug 2006
- Location: Global Citizen
- Has thanked: 1033 times
- Been thanked: 2223 times
EasyLanguage is very powerful; it can practically do any calculation and analysis you can imagine.
You can begin here:
Getting Started with EasyLanguage
http://www.tssupport.com/support/tutorials/
The book is not difficult, but will require some time and patience to read ...
The skill you acquired will repay your time investment in multifolds.
You can begin here:
Getting Started with EasyLanguage
http://www.tssupport.com/support/tutorials/
The book is not difficult, but will require some time and patience to read ...
The skill you acquired will repay your time investment in multifolds.
-
- Posts: 1
- Joined: 29 Aug 2009
- Andrew Kirillov
- Posts: 1589
- Joined: 28 Jul 2005
- Has thanked: 2 times
- Been thanked: 31 times
- Contact:
The second data series should be used:can EL statement be written to create OHLC for a speified Points or Range size bars,so that an indicator or signal can use those values for OHLC?.
Point or Range bar size will not be same as chart data.
Does anyone have or know where I can find the formula for Points (Range)? Wanting to use it in a script.
Data series #1 - your original data series (OHLC chart)
Data series #2 - your Point/Range bar data series
Use following statements to get data from Points/Range chart:
Code: Select all
Open of data2
High of data2
Low of data2
Close of data2