I would like to utilize the prebuilt signal in MultiChart .Net (eg.
MovAvg2Line cross LE and SE signals). However, it appears that this strategy is limited only to "simple moving averages". The system I want to implement is
Simple MA AND
Displaced Exponential MA, which in fact are both available as Indicators. Hence I can plot both Simple MA and Displaced EMA on the chart but I can't use them when it comes to signals.
Here's what I would like for the entry/exit signals:
Code: Select all
Buy = SMA(20) crossed above EMA(28, -14)*
Sell = SMA(20) crossed below EMA(28, -14)
*EMA(28, -14) = 28-Period Exponential Moving Average with an Offset (ie. displaced backwards) of 14-periods.
I wish there was a way to choose the value/parameter (as well as the type of MA) for the signals as there is for the indicators. This is by no means a complicated formula and I would think tweaking a line or two of codes would fix the issue but not knowing anything about C# I'm inclined to reach out for any assist.