Hello,
The locals, autos, and watch 1 debug windows are empty and I cant figure out how to make them show values. I have attached to Multicharts.NET but I'm sure I'm missing other required options.
I also can't set a breakpoint. I get the "A breakpoint could not be inserted at this location" error.
Any help would be much appreciated.
Thank you
Debugging
- Tammy MultiCharts
- Posts: 200
- Joined: 06 Aug 2020
- Has thanked: 6 times
- Been thanked: 65 times
Re: Debugging
Hello Kghiasv,
Please try the following steps:
1. Run PowerLanguage .NET Editor.
2. Click Launch VS 2010 on the toolbar (Visual Studio will open).
3. In the Solution Explorer window select the indicator for debugging.
4. Insert the breakpoints.
5. Select Debug > Start Debugging (MultiCharts .NET will run).
6. Plot a chart and apply the indicator to it.
Once the indicator is calculated on the data, the breakpoints will work.
Please try the following steps:
1. Run PowerLanguage .NET Editor.
2. Click Launch VS 2010 on the toolbar (Visual Studio will open).
3. In the Solution Explorer window select the indicator for debugging.
4. Insert the breakpoints.
5. Select Debug > Start Debugging (MultiCharts .NET will run).
6. Plot a chart and apply the indicator to it.
Once the indicator is calculated on the data, the breakpoints will work.