I was tired to see MC giving me a slow refresh when scrolling over a large numbers of bars so I install MC 64. Sadly, I still have the same issues. Basically, refresh of the chart is done line every .05 second, so not very fluid.
I finally found that the problem is mainly cause by one of my indicator. When I turn it off, scrolling is fluid, turn on, refresh is slow.
I did turn off certain part of the software to realized that the slow down is cause by the section that is using "Text" function to write "-" in the middle of a bar
When I turned off this section, scrolling of the chart is more fluid
Code: Select all
If ShowWRBMiddle = true then begin
If A_WrbWhite or A_WrbBlack then begin
TextVal = text_new_s(Date[1],Time_s[1],WRB_Midpoint(Open[1],Close[1]),"-");
// Print ( Time_s[1], " ", WRB_Midpoint(Open[1],Close[1]):5:5,">");
Value1 = Text_setColor(TextVal, Red);
Value1 = Text_setStyle(TextVal,0,SetStyle );
Value1 = Text_SetSize(TextVal,WRBMiddleSize);
end;
Martin
P.S.
Any suggestion on video recorder that I could use to show the problem?