"Upgraded" to 15.. Install and update went fine... Rebooted computer 2x... Opened 15 and all looks good... Clicked on simulated trading to test and Its kinda working-- but VERYYYYYY slow... When i slide the speed slider all the way to the right/fastest (where it used to do the whole range almost instantly) -- now you can see each tick by tick -- super slow..
So first question is-- any idea on things i can do to get the speed back up?
If there isnt-- What is the best way to revert back to 14?
Simulated testing struggling after updating to 15
Re: Simulated testing struggling after updating to 15
Couldnt figure out how to fix the testing speed to a decent speed... ... So went back to 14.10... Though with that said--- looking forward to 15 once the testing speed is figured out... ... Its almost like the speed bar was locked to 3 or 4 out of 10... Even though it was maxed out.. I was testing renko/tick..
- Polly MultiCharts
- Posts: 206
- Joined: 20 Jul 2022
- Has thanked: 1 time
- Been thanked: 56 times
Re: Simulated testing struggling after updating to 15
Hello BB123,
Thank you for your feedback.
Please answer the following questions so that we could analyze the issue:
Thank you for your feedback.
Please answer the following questions so that we could analyze the issue:
- What symbol and data vendor were you using?
- What mode of simulated trading did you set up?
- What resolution did you use?
-
- Posts: 19
- Joined: 19 Dec 2023
- Has thanked: 1 time
Re: Simulated testing struggling after updating to 15
I had a similar experience both in standard and advanced version. But I was using 987 tick charts on NQ using Rithmic data feed. It speeds up but no where near as much as it should in my opinion. I could be waiting hours for an entire day to be played back.
- Polly MultiCharts
- Posts: 206
- Joined: 20 Jul 2022
- Has thanked: 1 time
- Been thanked: 56 times
Re: Simulated testing struggling after updating to 15
Dear users,
If the issue is still reproduced, please send us logs via the main MultiCharts window -> Help -> Feedback, so that we could check that behavior.
Please select the options:
If the issue is still reproduced, please send us logs via the main MultiCharts window -> Help -> Feedback, so that we could check that behavior.
Please select the options:
- Attach a screenshot;
- Attach log files…;
- Snapshot of the current MC setup;
- Open workspaces…;
- Data for active instruments…;
- Upload collected data to help desk;