Comparing Charts to Scanner: Difference between revisions
From MultiCharts
→Comparing indicator values on charts and in scanner
Abeloglazova (talk | contribs) |
Abeloglazova (talk | contribs) |
||
Line 15: | Line 15: | ||
==Comparing indicator values on charts and in scanner== | ==Comparing indicator values on charts and in scanner== | ||
If | If there is a discrepancy in the chart and scanner indicator’s calculations, it may be related to one of the following: | ||
* different symbol settings ([[Comparing_Charts_to_Scanner#Comparing_instrument_values_on_charts_and_in_scanner|see point 1 of this article]]); | * different symbol settings ([[Comparing_Charts_to_Scanner#Comparing_instrument_values_on_charts_and_in_scanner|see point 1 of this article]]); | ||
* different indicator settings. In this case compare and adjust: | * different indicator settings. In this case compare and adjust: | ||
Line 24: | Line 24: | ||
# the [[Indicator_Settings#Advanced_properties|Skip identical ticks option]] state. | # the [[Indicator_Settings#Advanced_properties|Skip identical ticks option]] state. | ||
Also verify that you | Also verify that you did not use an additional data series in the indicator’s calculation on the chart, because in the Scanner you can only use Data1 for calculations. If you still observe the differences in the indicator values, cross-check the logic of the indicator. | ||
If you still observe the differences in the indicator values, cross-check the logic of the indicator. | |||
[[Category: Real-Time Market Scanner]] | [[Category: Real-Time Market Scanner]] |