Is it possible to print a down arrow and then a value above the arrow ? For example ,I want to put a Red arrow on top of a bar if High-Close value is more than 10% of the Bar's Range (High-Close) and then above the arrow print the value of High-Close .I also want to print High-Low value (Range)
below the OHLC bar as shown in the picture.
In the example picture attached 12 is the value of High-Close and 80 is the value of High-Low
Printing Values above and Below Bar
Printing Values above and Below Bar
- Attachments
-
- 1-BAR SHORT SIGNAL.png
- (10.31 KiB) Not downloaded yet