Is the best way to write a signal, using multiple time frames, using ADE (All Data Everywhere)? Tried to use data1, data2, data3, but the result does not seem right (using multiple funtion that I made on to just the data they used to).
Is there anyone running ADE / Elcollections on MC 7?
ADE / Elcollections on MC 7
- TJ
- Posts: 7744
- Joined: 29 Aug 2006
- Location: Global Citizen
- Has thanked: 1033 times
- Been thanked: 2223 times
Re: ADE / Elcollections on MC 7
what do you mean by "the result does not seem right"?Is the best way to write a signal, using multiple time frames, using ADE (All Data Everywhere)? Tried to use data1, data2, data3, but the result does not seem right (using multiple funtion that I made on to just the data they used to).
Is there anyone running ADE / Elcollections on MC 7?
can you describe?
can you post some screen shots with notes to highlight the error?
Re: ADE / Elcollections on MC 7
Hello TJ.
Unfortunately, I deleted it because it did not work. The error due to my ignorance.
Dont know if I was right when I wrote:
Close of data2, High of data2, Average (C, 30) of data2, Lowest (C 30) of data2 etc.
Is the result the same if I uses data1, data2, data3 (correctly) that use of the ADE?
Unfortunately, I deleted it because it did not work. The error due to my ignorance.
Dont know if I was right when I wrote:
Close of data2, High of data2, Average (C, 30) of data2, Lowest (C 30) of data2 etc.
Is the result the same if I uses data1, data2, data3 (correctly) that use of the ADE?
- TJ
- Posts: 7744
- Joined: 29 Aug 2006
- Location: Global Citizen
- Has thanked: 1033 times
- Been thanked: 2223 times
Re: ADE / Elcollections on MC 7
Sorry... can't tell without specifics.Hello TJ.
Unfortunately, I deleted it because it did not work. The error due to my ignorance.
Dont know if I was right when I wrote:
Close of data2, High of data2, Average (C, 30) of data2, Lowest (C 30) of data2 etc.
Is the result the same if I uses data1, data2, data3 (correctly) that use of the ADE?