Simulated testing struggling after updating to 15

"Upgraded" to 15.. Install and update went fine... Rebooted computer 2x... Opened 15 and all looks good... Clicked on simulated trading to test and Its kinda working-- but VERYYYYYY slow... When i slide the speed slider all the way to the right/fastest (where it used to do the whole range almost instantly) -- now you can see each tick by tick -- super slow..

So first question is-- any idea on things i can do to get the speed back up?

If there isnt-- What is the best way to revert back to 14?

Couldnt figure out how to fix the testing speed to a decent speed... ... So went back to 14.10... Though with that said--- looking forward to 15 once the testing speed is figured out... ... Its almost like the speed bar was locked to 3 or 4 out of 10... Even though it was maxed out.. I was testing renko/tick..

Hello BB123,

Thank you for your feedback.

Please answer the following questions so that we could analyze the issue:

• What symbol and data vendor were you using?
• What mode of simulated trading did you set up?
• What resolution did you use?

Also please send us your workspace to our support email so that we could check it in detail.

I had a similar experience both in standard and advanced version. But I was using 987 tick charts on NQ using Rithmic data feed. It speeds up but no where near as much as it should in my opinion. I could be waiting hours for an entire day to be played back.

Dear users,

If the issue is still reproduced, please send us logs via the main MultiCharts window -> Help -> Feedback, so that we could check that behavior.
Please select the options:

• Attach a screenshot;
• Attach log files…;
• Snapshot of the current MC setup;
• Open workspaces…;
• Data for active instruments…;
• Upload collected data to help desk;

uncheck other options and click Send.