What is the best and supported way to create DLL?
The MC help points to:
https://www.TS.com/support/bo ... on_sdk.pdf
for documentation on how to build extensions.
This documentation talks about tskit.dll as the way to build DLLs but only elkit.dll is located in the MC program directory.
The EL doc says that elkit.dll is "legacy".
Please advise.
[Advanced Topic] Getting started with DLL
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
There are a couple of issues but they are all described in the document I referred to earlier. Apart from that, if you come across any problems you could contact us and we'd try to help you.
I searched the document:
https://www.TS.com/support/bo ... on_sdk.pdf
for anything with "thread" in it but found nothing.
Can you point me to the specific mention of the issues?
Thanks.
- Marina Pashkova
- Posts: 2758
- Joined: 27 Jul 2007
I just consulted our engineers and they told me that the document contains all the necessary information. It is not obvious but it is there. I would recommend reading and analyzing the document carefully. The information is sufficient to understand what you should pay attantion to.
Also, you could experiment creating dlls and you will see how they function and what issues are there.
Regards,
Marina
Also, you could experiment creating dlls and you will see how they function and what issues are there.
Regards,
Marina