I created a second desktop because it seems to balance the load between processors. One scanner window and one chart running on each desktop.
Second desktop Scanner window stopped updating indicators. The one chart was updating its indicators which is why I noticed the discrepancy.
J~
Ver 5.0 Scanner problem
Re: Ver 5.0 Scanner problem
[quote]I created a second desktop because it seems to balance the load between processors. One scanner window and one chart running on each desktop.
Second desktop Scanner window stopped updating indicators. The one chart was updating its indicators which is why I noticed the discrepancy.
J~[/quote]
The reason the indicators stopped updating is the data stopping updating to certain symbols. The data is updating ok to same symbols on the charts linked to the symbols so something is very wrong. Please check into this.
J~
Second desktop Scanner window stopped updating indicators. The one chart was updating its indicators which is why I noticed the discrepancy.
J~[/quote]
The reason the indicators stopped updating is the data stopping updating to certain symbols. The data is updating ok to same symbols on the charts linked to the symbols so something is very wrong. Please check into this.
J~
The problem with data and indicators stopping along with the problem of "Not enough bars" on a previously running scanner window seem to occur only with multiple desktops. While the problem occurred repeatedly throughout the previous two days with two desktops , when I ran a single combined desktop which included all the symbols and indicators from the two separate desktops the problem did not occur after running all day. So it would seem there are some communication difficulties in running multiple scanner desktops. I also notice a problem with alerts. For whatever reason alerts keep repeatedly turning themselves on.
J~
J~
-
- Posts: 261
- Joined: 28 Feb 2008
- Has thanked: 2 times
- Been thanked: 1 time