Hi,
I have two series of data on the same chart with different resolutions, In some cases when series 2 (higher res) is missing a bar it interferes with my strategy calculation, for ex. in the image below i have a rule to add blue arrows as long as the bar is lower than the red line:
although the rule is still valid it wont draw the arrows until the bars will be higher than the red line and back below once again..
how can I set the chart, by code or settings, to avoid such behavior?
Thx much in advance,
Best,
R.
missing bar stops calculation
- Henry MultiСharts
- Posts: 9165
- Joined: 25 Aug 2011
- Has thanked: 1264 times
- Been thanked: 2958 times
Re: missing bar stops calculation
Hello Ram,
Please send us (support@multicharts.com) the following information for further analysis:
- workspace you are using;
- in QuoteManager select the symbols you are using, make a right click on it->Export data->Export instrument (with data). Send us the QMD export file for analysis;
- in PowerLanguage .NET editor->File->Export->export the studies you are using for replicating this behavior; send us the pln file;
- specify the version and build number of MultiCharts you are running (in MultiCharts go to Help tab-> About);
- instructions for replicating this behavior.
Please send us (support@multicharts.com) the following information for further analysis:
- workspace you are using;
- in QuoteManager select the symbols you are using, make a right click on it->Export data->Export instrument (with data). Send us the QMD export file for analysis;
- in PowerLanguage .NET editor->File->Export->export the studies you are using for replicating this behavior; send us the pln file;
- specify the version and build number of MultiCharts you are running (in MultiCharts go to Help tab-> About);
- instructions for replicating this behavior.